Table of Contents
Advertisement
Section 1: Assembly & Set-Up
Implement Hook-Up to QH20
Go to page 13 for "Implement Hook-Up to QH05"
Go to page 14 for "Implement Hook-Up to QH16"
Go to page 18 for "Implement Hook-Up to QH30"
NOTE: Quick Hitch hook-up to tractor is required
before proceeding with implement hook-up.
!
DANGER
To avoid serious injury or death:
A crushing hazard exists while hooking-up and unhooking the
implement. Keep people and animals away while backing-up
to the implement or pulling away from the implement. Do not
operate hydraulic controls while a person or animal is directly
behind the power machine or near the implement.
!
CAUTION
To avoid minor or moderate injury:
Release Handles have areas where pinching can occur. Keep
hands, fingers, and other body parts away from the pivoting
areas of the release handles. Always use the handle grips.
Lower Hitch Pin Set-up
Refer to Figure 1-7:
1.
Two 890-938C lower bushings (#1) and roll pins (#2)
are in a bag nailed to the crate.
2. Install bushings (#1) onto lower hitch pins. Secure
bushings by inserting roll pins (#2) through bushings
(#1) and hitch pins (#5) as shown. This will provide a
tighter and more secure mounting in the Quick Hitch
auto-lock hooks.
3. Continue with "Hook-up Without Floating Top
Links" at the bottom of this page.
Lower Clevis Pin Set-up
Refer to Figure 1-8:
1.
Two 890-938C lower bushings (#1) and roll pins (#2)
are in a bag nailed to the crate. Roll pins (#2) are not
required in this application.
2. Install flange bushings (#1) over implement hitch
pins (#6) or customer can supply 1 7/16" OD
bushings (#3) in lieu of flange bushing (#1). See
"QH20 Spare Bushings" on page 16.
3. Secure hitch pin (#6) with customer supplied
linchpin (#4).
4. Continue with "Hook-up Without Floating Top
Links" below.
16
QH05, QH16, QH20, & QH30 Quick Hitches 320-003M
Table of Contents
QH20 Spare Bushings
Additional bushings may be purchased from your local
Land Pride dealer so that more than one implement is
readily available for quick hook-up.
Part No.
890-938C
890-939C
890-940C
890-941C
24877
QH20 Hook-up to Implement With Lower Hitch Pins
24877
QH20 Hook-up to Implement With Lower Clevis Pins
QH20 Lower Bushings
Part Description
Stepped Bushing CAT. ll to CAT. lll Adapter
Spacer Tube 1.44" O.D. x 1.14" I.D. x 1 3/4" lg.
Spacer Tube 1.44" O.D. x 1.14" I.D. x 2 1/2" lg.
Spacer Tube 1.44" O.D. x 1.14" I.D. x 2 3/4" lg.
Upper Hitch Point
Release Handle
Upper
Hook
Auto-lock
Hook
Figure 1-7
Upper Hitch Point
Release Handle
Upper Hook
Auto-lock
Hook
Figure 1-8
7/15/22
Advertisement
Table of Contents
