Table of Contents
Advertisement
input selection and AV connections
The Timer
The television can be set to turn itself OFF after a
certain time.
Select Timer from the top menu bar.
1
Timer
Off timer
0 – 9
: To set
EXIT
: To exit
Press Q to select Off timer. Use the number
2
buttons to set the required time. For example, to
switch the television off in one and a half hours
enter 01:30, or use S and R to increase/decrease
in steps of 30 minutes.
Press EXIT to finish.
3
To turn the television back on press
the number buttons.
The Time Display
The time display facility allows the current time to be seen
on the television screen.
Press
/
whilst watching a normal television
8
9
broadcast to see a time display from the broadcaster. It
will remain on screen for about 5 seconds.
The timer, time display,
00:00
or one of
i
Defining the INPUT and OUTPUT sockets so
that the television recognises connected
equipment. See page 6 for a clear view of the
back connection recommendations.
Most VCRs and decoders send a signal through the
SCART lead to switch the television to the correct Input
socket. Alternatively press the external source selection
button
until the picture from connected equipment is
B
shown.
An S in the display e.g. EXT2S, indicates the input is set
for an S-Video signal.
Use the Input Selection if the television does not switch
Press
1
B
To return to television mode press
2
one of the numbered buttons.
INPUT signal selection
This specifies the type of signal going into SCART 2
(EXT2) on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
From the Set up menu select EXT2 input
1
and with S or R select either AV or
S-VIDEO as the required input.
If the colour is missing try the alternative setting.
Set up
Language
Auto tuning
Manual tuning
Programme sorting
EXT2 input
Horizontal position
EXIT
16
Input selection
over automatically.
to select EXT1, EXT2 or EXT3.
B
z
ENGLISH
z
: To exit
again or
x
x
x
x
AV
x
zx
Advertisement
Table of Contents
