Advertisement
CV-550SPK V3 WATERPROOF KEYPAD
INSTA L L AT I O N I NST RU CTI ONS
Wiring the CV-550SPK V3 to an Access Controller (Wiegand Out)
5. INSTALLATION
CV-550SPK V3 Wall Flush Mounting with Rain/Privacy Shield:
CV-550SPK V3 Wall Flush Mounting with Rain/Privacy Shield:
Note: Make necessary arrangements for wiring before
Note: Make necessary arrangements for wiring before
Mounting the Keypad to the wall.
Mounting the Keypad to the wall.
1.
Remove the mating screw located at the bottom of the
1.
keypad, allowing you to mount the keypad with the Rain/Privacy
Remove the mating screw located at the bottom of the
Shield to the wall.
keypad, allowing you to mount the keypad with the Rain/Privacy
Shield to the wall.
2.
Spot drill hole on the wall and take the supplied Self
threading screws to tighten back of the Keypad to the
2.
Spot drill hole on the wall and take the supplied Self
Rain/Privacy Shield.
threading screws to tighten back of the Keypad to the
Rain/Privacy Shield.
3.
Place the front of the keypad onto the back of the
keypad then tighten with the mating screw to keep keypad
3.
in place.
Place the front of the keypad onto the back of the
keypad then tighten with the mating screw to keep keypad
in place.
CV-550SPK V3 Inwall Electrical Box Flush
Mounting with Rain/Privacy Shield:
CV-550SPK V3 Inwall Electrical Box Flush
Note: Thread the Keypad wire through the rain
Mounting with Rain/Privacy Shield:
hood to make necessary arrangements for wiring
Note: Thread the Keypad wire through the rain
before Mounting the Keypad.
hood to make necessary arrangements for wiring
before Mounting the Keypad.
1.
Remove the mating screw located at the
1.
Remove the mating screw located at the
bottom of the keypad, allowing you to mount the
bottom of the keypad, allowing you to mount the
keypad with the Rain/Privacy Shield to the Electrical Box.
keypad with the Rain/Privacy Shield to the Electrical Box.
2.
Take the supplied #6-32 screws and place it
2.
Take the supplied #6-32 screws and place it
through the center top and bottom holes on the
through the center top and bottom holes on the
Keypad back plate, through the Rain/Privacy Shield then
Keypad back plate, through the Rain/Privacy Shield then
tighten screws to keep the plate and Rain/Privacy Shield
onto the electrical box.
tighten screws to keep the plate and Rain/Privacy Shield
onto the electrical box.
3.
Place the front of the keypad onto the back
of the keypad then tighten with the mating screw
3.
Place the front of the keypad onto the back
to keep keypad in place.
of the keypad then tighten with the mating screw
to keep keypad in place.
Page 6 of 7
+12V
Red
ALARM
Grey
NC
Orange
Blue
NO
COM
Purple
D_IN
Brown
OPEN
Yellow
GND
Black
Green
D0
D1
White
CV-550SPK V3
CV-550SPK V3
Rain/Privacy Shield
CV-550SPK V3
CV-550SPK V3
Mating Screw
Mating Screw
Access Controller
Reader Terminal
+
-
D0
D1
Rain/Privacy Shield
Rain/Privacy Shield
Inwall SingleGang
Electrical Box
Inwall SingleGang
Electrical Box
Rain/Privacy Shield
6-32 Mounting
Screw
6-32 Mounting
Screw
Rain/Privacy Shield
Rain/P
Thread screws
through these
Thr
four holes
thr
f
2"
[50mm]
Advertisement
