2 Set Up the Machine
7
Press [OK] to proceed to the "Setup Guide. "
8
Fan the paper stack and even the edges.
9
Load the paper stack of the appropriate size
with the print side facing up. Align the rear edge
of paper stack with the rear paper guide.
–
When loading paper, be careful not to cut your fingers on
the edges of the paper.
–
Make sure the paper stack does not exceed the load limit
mark (A).
–
The optional paper drawer holds approximately 500
sheets of paper (20 lb (75 g/m
10
Press [OK] to proceed to the "Setup Guide. "
16
)).
2
11
Hold the optional paper drawer with both
hands and set it back into the machine.
12
Push the paper drawer as far as it will go.
–
Be careful not to get your fingers caught.
–
For details on loading paper in the stack bypass tray, see
"Introduction of the Machine, " in the e-Manual.
–
If you loaded a size and/or type of paper that is different
from what you registered in the "Setup Guide, " you need
to change the paper settings on the machine. See
"Change the Settings, " on p. 36.
13
Press [OK] to proceed to the "Setup Guide. "
14
Make sure the following screen is displayed
on the display, then press [OK] to proceed to
the "Setup Guide. "