Canon Color imageCLASS MF8450c Starter Manual page 13

Check that all the packing materials are removed from the
main unit and the cartridges. If not, refer to the instruction
sheet "Unpacking the Machine" and remove them all.
4
Make sure the following screen is displayed on
the display, then press [OK] to proceed to the
"Setup Guide. "
The auto obtain IP address function will enables the
machine to get the IP address after connecting the LAN
cable to the machine.
–
If the LAN cable has not been connected yet, connect it as
described in "Connect the LAN Cable, " on p. 8.
–
Connect the LAN cable when you use the machine to
share with a group through the network.
–
Connect the LAN cable even if you do not use the auto
obtain IP address function, because your network
environment requires the IP address to be set manually.
5
Make sure the following screen is displayed on
the display, then press [OK] to proceed to the
"Setup Guide. "
Do not connect the USB cable at this point even if you use
the machine as a local printer by directly connecting the
machine to the computer.
During the software installation procedure, you can connect
the USB cable. (When using the network function, the USB
cable is not required.)
6
Make sure the following screen is displayed on
the display.
Go to "Load Paper," on p. 12.
If the toner cartridges have not been set in the machine or
the tabs and tape have not been removed from the toner
cartridges, the <Set Toner Cartridge Again> screen appears.
You will need to finish the cartridge installation before you
proceed. (See "Install Toner Cartridges, " on p. 4.)
2 Set Up the Machine
11