70
Darning foot height
Standard:
•
Attach darning foot.
•
Drop feed-dog.
•
Turn handwheel until presser-foot bar
reaches its lowest position.
•
Use gauge 87 to check distance (0.5 mm)
between stitch plate and darning foot
sole.
Correction:
•
Remove adjusting wheel lock 161.
•
Remove adjusting wheel 162.
•
Pin loop lift position (balance piece).
•
Loosen screw 88 on hopper mechanism
lever.
•
Place presser foot on gauge 87.
•
Tighten screw 88 - take care with cam
position.
•
Refit adjusting wheel 162.
•
Refit adjusting wheel lock 161.
•
Check functioning.
•
See also presser foot height illustration on
page 69.
Position of the hook driver in the hook race
Standard:
The hook driver should be 0.1-0.15 mm
behind the front edge of the hook race.
Correction:
•
Loosen screw 169 on driver shaft.
•
Move complete driver into prescribed
position.
•
Retighten screw 169 flat.
88
Lift here to achieve 0.5mm
87
0,5 mm
169