Upgrade Device Firmware; Restore To Factory Settings - Kiloview RE-1 V2 Quick Start Manual

8.2 Upgrade device firmware

Login to the web page of RE-1 V2, click "Settings">"Firmware Upgrade" to check if there is any latest firmware
available to download.If yes,select the downloaded firmware and click "Firmware Upgrade".
After uploaded the firmware successfully, it needs to reboot the device. After clicking "ok", the device will
restart, please be patient.
Note
⚫
Please do not power off during the upgrade process, otherwise the device couldn't work.
⚫
Generally, it will take 3-5 minutes to upgrade the device. If it's still not completed after 5 minutes, please try refreshing
webpage, if you still can't access it, please try to contact for technical support.

9 Restore to factory settings

If the device cannot work normally after modified the parameters or forgot internet IP configuration and
couldn't search and find the device, please restore factory settings.
Two methods for restoring factory settings:
1) If you can login to web page, then via the web page, click "Settings>System settings>Restore factory
settings".
2) If you can't login to web page, press the RESET button for 5 seconds in the bottom of device.
Note: After restoring factory setting, below parameters will be turned to default value:
⚫
Login username and password will be "admin".
⚫
Your device will be restored to obtain a DHCP-assigned IP address by default and the failover address 192.168.1.168 will
be bound to the device.
⚫
All encoding parameters of video and audio will be restored to default value.
9
Page