Table of Contents
Advertisement
4 Device Connection
SDI source
Note
⚫
Rack-mounted equipment is equipped with dual power supplies, and can operate normally with only one power input
device. When dual power supplies are connected, it will be used as a redundant power supply backup.
⚫
Please make sure the camera is connected to the SDI IN port.
⚫
Loop is not a must, connect SDI OUT when you need to loop. After connecting the power cable, turn it on and off through
the corresponding power switch.
5 Device Discovery
5.1 Direct visit by default IP
The default fixed IP address of RE-1 V2 is 192.168.1.168. Please configure your computer network to
192.168.1.xxx when you use it for the first time, and then enter http://192.168.1.168/ in the browser to visit
Web UI.
LOOP
Switcher
backup power
AC100~240V Power Supply
PC
Power Cable
3
Page
Advertisement
Table of Contents
