To Change The Display Clear (Reset) Method; Entering The Limits Value; Power Standby Mode - Jetco TTS-1000 Operation Manual

...
...
AUto...OFF...1sec.....9sec
hold to change
. . .
To change the display clear method
1. Press the menu keys.
2. Press the next key 6 times or until the "Auto
Reset" icon shows.
3. Press the save key to select the Auto Reset
function.
4. Press the next key until:
"AUt0" shows (Auto sense)
"Off" (manual clear using the clear key)
"1.......9" (seconds before the display clears
itself)
5. Press the save key to store new setting.
Note:
If auto sense is selected the torque meter will
automatically clear the display when a new
torque cycle begins. This means that you do not
have to continually reach up and clear the display
manually.
Entering the limits (tolerance) settings.
1. From the operation mode press and hold the
limits on/off key.
If you have set the % function set then the meter
will prompt you to enter the target tolerance (it will
automatically calculate the limits).
If you have the high/low function set then the
meter will first prompt you to enter the low limit
and then the high limit.
Power saving standby mode
When the torque meter has not been used for
approximately 3 minutes it will go into the power
down or "standby" mode.
". . .".
Press the clear key to get back to normal
operation. For the longest life from the batteries
turn the meter off when not used.
12
The display will show