To Change The % Tolerance Value; To Make High Low Limits The Default Tolerance Method - Jetco TTS-1000 Operation Manual

Tolerance vs High Low (Go/No Go Calculation)
To select and change the % tolerance value from
the current setting
1. Press the menu keys.
2. Press the next key 5 times or until "tolerance" shows.
3. Press the save key to select the tolerance function.
4. Press the next key until "% On" shows.
5. Press the save key.
6. Enter the new % value (01-99%) with the increase and
next keys (see "entering numbers").
7. Press the save key when the value is correct.
To make high/low limits the default tolerance
1. Press the menu keys.
2. Press the next key 5 times or until "tolerance" shows.
3. Press the save key to select the tolerance function.
4. Press the next key until the high/low arrows show.
5. Press the save key to store the new tolerance setting.
Note:
Once you change the tolerance mode it will become the
new default tolerance mode each time the torque meter is
turned on.
Now when you set the limits (press and hold the limits
on/off key) you will be prompted to set the high and low
limits instead of the target torque.
mode
11
...
On
%
02
%
On
%
On