Canon imagePROGRAF iPF8300 Basic Guide No.3 Basic Manual page 7

5
Grasp the Belt , insert it between the Belt Stopper , and
affi x the Belt Stopper with a hex screw at the position
indicated.
• Here, the Belt Stopper is the one that was removed and stored after initial installation. Neglecting to
attach the Belt Stopper may damage the printer.
6
Close the Top Cover .
7
Tape down printer covers to secure them, in the reverse
order of tape removal during installation.
8
If the Output Stacker is installed, reverse the installation
procedure to remove the Output Stacker .
9
Remove the Stand by reversing the installation procedure,
when it was attached to the printer.
10
Disassemble and repackage the Stand by following the
installation procedure in reverse.
11
Repack the Roll Holder , Holder Stopper , and printer in
shipping materials, and then package them in a shipping
box.
7
Preparing to Transfer the Printer