Opengear ACM5004-LR Quick Start Manual page 2

Step 3 Set u p a ppliance n etworking
The appliance's default IP address is 192.168.0.1 (subnet mask 255.255.255.0 ). With a
web browser on any computer that is connected to the appliance via LAN USB 1 :
Enter https://192.168.0.1 into the address bar
Ø
Log in using the default system user name root and the default password
Ø
default, a Welcome screen listing the basic configuration steps is displayed
Note:
(192.168.0.x) as the appliance. The appliance also has DHCP client enabled by default.
It will automatically accept any network IP address assigned by any DHCP server on
your network, and will then respond at both 192.168.0.1 and its DHCP address.
Select Serial & Network: Users & Groups and Edit the Root User . Enter and
Ø
confirm a new Password and click Apply
Select System: IP then Network Interface ( LAN USB 1) and check DHCP or
Ø
Static for Configuration Method
Note:
used to access which ports and devices. By default only HTTPS and SSH access is
enabled to the appliance itself. Use the Service Access menu on System: Services
to change settings for the appliance itself (and for connected serial ports).
Step 4 Connect t he c ellular m odem
Note:
start and stop dynamically (e.g. in response to a loss of primary network connectivity).
For an overview of failover configurations, refer to the Knowledge Base FAQ article
Automatic failover to alternate broadband, cellular or dial-out Internet
connection.
To set up an always-on cellular connection:
Select System: Dial then the Internal Cellular Modem tab
Ø
ACM5004-­‐LR Q uick S tart ( 520083-­‐Rev 1 .0)
The computer must have an IP address in the same network range
The appliance's firewall determines which protocols and services can be
In OOB only mode the cellular modem may be always-on, or configured to
Page 2