Table of Contents
Advertisement
Information codes
If the washing machine fails to operate, you may see an information code on the screen. Check the table
below and try the suggestions.
Code
Check the water level sensor.
• Power the washing machine off. Wait 2-3 minutes, power the washing machine on,
1C
and then try again.
• Depending on the model, the drain system may drain water automatically. The Power
and Start/Pause (Hold to Start) buttons may be disabled during this process.
The door is open.
DC
• Close the door and press Start/Pause (Hold to Start) to resume operation.
Check the door switch.
DC1
• Power the washing machine off. Wait 2-3 minutes, power the washing machine on,
and then try again.
Check for water leaks.
• Power the washing machine off, and then check the drain system for any leaks. Once
LC
the leak issue is resolved, power the washing machine on.
• Depending on the model, the drain system may drain water automatically. The Power
and Start/Pause (Hold to Start) buttons may be disabled during this process.
Check the water supply line.
• Check the connection to the water lines (including water taps).
• Power the washing machine off. Wait 2-3 minutes, power the washing machine on,
4C
and then try again.
• Depending on the model, the drain system may drain water automatically. The Power
and Start/Pause (Hold to Start) buttons may be disabled during this process.
Laundry needs protection because the water being supplied is too hot.
• Make sure the cold and hot water taps are properly connected.
4C2
• Power the washing machine off. Wait 2-3 minutes, power the washing machine on,
and then try again.
Check the drain system.
5C
• Make sure the drain filter is not clogged.
• If the drain filter is clogged, clean the filter, and then restart the washing machine.
Check the washing heater.
HC
• Power off the washing machine, and then contact a Samsung service center.
Untitled-1 51
Action
English 51
2022-01-19
3:51:28
Advertisement
Table of Contents
