Acorp 4845GVQ Manual page 3

Contents
2. Remove the FDD Bay-panel and HDD Bay-panel ................ 75
3. Remove the HDD Bay . ....................................................... 75
4. Connect Power Cord to on-board Power Connector .......... 75
5. Connect IDE/FDD Cable to on-board connector ................. 75
6. Install RAM Modules to Memory Slots ............................. 75
7. Install CPU and then CPU Fan ............................................ 75
8. Install Floppy Disk Drive to Bay ......................................... 75
9. Install CD-ROM to Bay ...................................................... 75
10. Connect Audio Cable to CD-In1 and CD-ROM ................. 75
11. Install Hard Disk Drive ...................................................... 75
12. Install System Fan ............................................................. 75
13. Close the Cabinet .............................................................. 75
Appendices ................................................................................... 80
Appendix I Quick Jumper Setup .............................................. 80
Appendix II Test Report ......................................................... 81
Motherboard 4845GVQ
0-3