Connecting Via Usb; Connecting To A Computer; Other - Canon Microfilm Scanner 800II Instructions Manual

CE-IE-323-01 Page 21

Connecting Via USB

USB connectivity is achieved through the use of a SCSI-
USB converter connected to the scanner's SCSI port.
Connecting via USB means that scanning speeds are
slightly slower than when using the SCSI port.
USB port
• Use the Hi-Speed USB 2.0 port that is equipped nor-
mally to the computer.
• Install the latest Microsoft USB 2.0 drivers. For details,
contact an authorized Canon dealer.
• Complete functionality using the USB interface is not
guaranteed. For details, contact an authorized Canon dealer.
USB cable
Use the supplied USB cable or a Hi-Speed USB 2.0 cable.

Connecting to a Computer

Setup, configuration, and connection of the scanner to the
computer should be done by the supervising service per-
sonnel. To change the connection or settings, contact an
authorized Canon dealer or service professional.
IMPORTANT
• The interface cable for connecting to the computer
should match the interface used during setup.
• After connecting interface the cable to the scanner,
attach the ferrite core supplied with the scanner to
the cable near the scanner. Do not remove the ferrite
core, since this is attached to suppress a cable-noise.
• You cannot use a SCSI and a USB connection at the
same time. Before changing the interface, make
sure to contact an authorized Canon dealer or
service professional.

Other

Software
• The ISIS-compatible application software or TWAIN-
compatible application software that operate normally
on the operation system described above.
• The ISIS/TWAIN driver provided with the scanner is
not necessarily compatible with all ISIS-compatible or
TWAIN-compatible application software. For details,
contact your application software dealer.
– 21 –
07.5.14, 11:06
Before You Begin...
Adobe PageMaker 6.5J/PPC