Cleaning Mode; Cleaning The Fuser Roller; Cleaning The Fixing Roller - Canon Microfilm Scanner 800II Instructions Manual

(Cleaning sheet)
CE-IE-323-01 Page 51

Cleaning Mode

Cleaning mode is a mode for cleaning the Fileprint 470's
fixing rollers. Clean the fixing rollers in the Fileprint 470 if
black spots appear on the front or back of the paper that is
printed out. The following describes the procedure for
cleaning the fixing rollers. Refer to the user's guide for the
Fileprint 470 for information about taking care of the
Fileprint 470.

Cleaning the Fixing Roller

1
Hold down the AE key for 5 seconds to switch to
Cleaning mode. "11" appears on the copies display.
2
Open the multipurpose tray on the FilePrint 470 and
load a sheet of Letter paper.
3
Press the Start key. A cleaning sheet is printed and the
copies display changes to "CL".
IMPORTANT
To cancel Cleaning mode, press the Clear key before
you press the Start key. You cannot cancel Cleaning
mode once you have printed the cleaning sheet. You
must complete the fuser cleaning procedure.
4
Load the cleaning sheet in the multipurpose tray with
the printed side down and the arrow marking facing
towards the printer.
5
Press the Start key to begin fuser cleaning.
IMPORTANT
Cleaning the fixing rollers requires about 75 seconds.
Other operations cannot be done while the fixing
rollers are being cleaned, so do not touch anything.
6
Once cleaning has finished, the copies display reverts to
its normal status.
IMPORTANT
If black spots still appear on the front or back of the
printouts after the fixing rollers are cleaned, instead
of using printed cleaning sheets, put blank A4 size
paper in the manual feed tray and clean them again.
– 51 –
07.5.14, 11:07
Maintenance and Troubleshooting
Adobe PageMaker 6.5J/PPC