Table of Contents
Advertisement
22
www.electrolux.com
Problem
You can hear a constant
beep noise.
You cannot select the
maximum heat setting
for one of the cooking
zones.
An acoustic signal
sounds and the hob de‐
activates.
An acoustic signal
sounds when the hob is
deactivated.
The hob deactivates.
Residual heat indicator
does not come on.
The control panel be‐
comes hot to the touch.
There is no sound when
you touch the panel sen‐
sor fields.
The indicator above the
symbol
Possible cause
The fuse is blown.
You do not set the heat
setting for 60 seconds.
You touched 2 or more
sensor fields at the same
time.
Pause operates.
There is water or fat stains
on the control panel.
The electrical connection is
incorrect.
The other zones consume
the maximum available
power.
Your hob works properly.
You put something on one
or more sensor fields.
You put something on the
sensor field
The zone is not hot be‐
cause it operated only for a
short time or the sensor is
damaged.
The cookware is too large
or you put it too close to
the control panel.
The sounds are deactiva‐
ted.
Child Safety Device or
Lock operates.
comes on.
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Activate the hob again and
set the heat setting in less
than 60 seconds.
Touch only one sensor field.
Refer to "Daily use".
Clean the control panel.
Disconnect the hob from the
electrical supply. Ask a quali‐
fied electrician to check the
installation.
Reduce the heat setting of
the other cooking zones con‐
nected to the same phase.
Refer to "Power manage‐
ment".
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Put large cookware on the
rear zones, if possible.
Activate the sounds. Refer to
"Daily use".
Refer to "Daily use".
Advertisement
Table of Contents
