Table of Contents
Advertisement
2. Clean the hood cavity with a cleaning
foam.
3. Wash the filter and filter housing
manually in warm water without using
detergents or abrasive sponges. You
can also wash them in a dishwasher
at 65-70 °C (using a program longer
than 90 minutes), without detergents
and without dishes in the same load.
Only the plastic parts can be cleaned
using detergents.
4. Dry the filter for 20-30 minutes in the
oven at 70 °C. Make sure to use a
non-fan oven function.
Fix the filter and filter housing back in
place when they are fully dried.
Regenerating the filter
The hob has a built-in counter that
reminds you about regenerating the filter.
9. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
9.1 What to do if...
Problem
You cannot activate or
operate the hob.
The counter starts automatically when
you turn on the hood for the first time.
After 100 hours of use the filter indicator
to regenerate the filter. The notification
stays on for 30 seconds after you
deactivate the hood and the hob. The
notification does not block the use of the
hob.
1. Clean the filter manually or in a
2. Put the filter in the oven set to
3. Fix the filter and filter housing back in
Reset the counter.
Resetting the counter
1. Clean and regenerate the filter first,
2. Press
The counter restarts.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
starts blinking to signal that it is time
The maximum number of
regeneration cycles is 6-7.
After that time, the filter
needs to be replaced with a
new one.
dishwasher, as described above
(normal cleaning).
80-110 °C for 60 minutes. Make sure
to use a non-fan oven function.
place.
then place it back inside the hood.
briefly, while the indicator is
blinking.
WARNING!
An oversaturated filter can
pose a risk of fire.
Remedy
Check if the hob is correctly
connected to the electrical
supply.
ENGLISH
21
Advertisement
Table of Contents
