Table of Contents
Advertisement
Installation and Connection
Installation and Connection
Parts list for installation
Note: This parts list does not include all the package
contents.
¥ Wiring harness (× 1)
ø Extension wire, 2 m (× 1)
π Flat head screws, M5 × 8 mm (× 6)
[ Round head screws, M5 x 8 mm (× 6)
" Microphone, 3 m (× 1)
] Trim plate (× 1)
' Mounting sleeve (× 1)
\ Extraction keys (× 2)
« GPS antenna, 3.5 m (× 1)
Å Metal plate (× 1)
Installation procedure
1
Remove the key from the ignition and
·
disconnect the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wires of the wiring harness
in the following order: ground, battery,
ignition.
5
Connect the wiring harness to the unit.
56
ENGLISH
6
Install the unit in your car.
Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (e.g., the
sound may skip).
7
·
Reconnect the
battery.
8
Initialize the unit (page 51).
9
Configure <Initial Settings> (page 4).
Installing the unit
Installing the unit using the mounting
bracket removed from the car
π / [
Note: Select the appropriate screws (supplied) for the
mounting bracket.
* Shape of your car brackets may differ.
Installing the unit using the mounting
sleeve
'
Bend the tabs of the mounting sleeve with a
π / [
screwdriver or similar utensil and attach it in place.
Installing the trim plate
Car bracket*
]
Advertisement
Table of Contents
