Installing The Unit - JVC KW-МІ 50ВТ Quick Start Manual

Installation
Ñ Supplied accessories for installation
1
3
(2 m)
5
(M5 × 6 mm)
Ñ Installation procedure
1) To prevent a short circuit, remove the key from
the ignition and disconnect the ¤ terminal of the
battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the wire on the wiring harness.
4) Take Connector B on the wiring harness and
connect it to the speaker connector in your vehicle.
5) Take Connector A on the wiring harness and
connect it to the external power connector on your
vehicle.
6) Connect the wiring harness connector to the unit.
7) Install the unit in your car.
8) Reconnect the ¤ terminal of the battery.
9) Press the reset button.
14
2
x1
4
(3 m)
x1
6
(M5 × 8 mm)
x6

Installing the unit

Ñ Japanese cars
x1
5 or 6
x1
x6
Ñ Microphone unit
1) Check the installation position of the microphone
(accessory 4).
2) Clean the installation surface.
3) Remove the separator of the microphone
(accessory 4), and stick the microphone to the
place shown below.
4) Wire the microphone cable up to the unit with it
secured at several positions using tape or other
desired method.
5) Adjust the direction of the microphone (accessory
4) to the driver.
Fix a cable with a commercial item of tape.
✎
NOTE
• Swap the clips if necessary.
Car Bracket
4
5 or 6