Display Symbols And Key Operation - A&D FX-iWP Series Instruction Manual

3-5 Display Symbols and Key Operation

Key operation
Key operation affects how the balance functions. The basic key operations are:
"Press and release the key immediately" or "Press the key"
= normal key operation during measurement
"Press and hold the key"
Display symbols
Each key, when pressed or when pressed and held, functions as follows:
Key When pressed
Turns the display on or off. The standby indicator is displayed when the display is
turned off. The weighing mode is enabled when the display is turned on.
This key is available anytime. Pressing the key during operation will interrupt the
operation and turn the display off.
In the weighing mode, turns the minimum
weighing value on or off.
In the counting or percent mode, enters
the sample storing mode.
Switches the weighing units stored in the
function table.
Refer to "4. WEIGHING UNITS".
Cancels the operation when performing
settings.
Outputs the weight data to a printer or
personal computer using the RS-232C
serial interface,
function table settings.
Confirms the operation when performing
settings.
Sets the display to zero.
depending on the
11
When pressed and held
Enters the function table mode.
Refer to "9. FUNCTION TABLE".
Enters the response adjustment mode.
Enters the calibration mode.
No function at the factory setting
By changing the function table:
Outputs "Title block" and "End block" for
GLP report.