Subscribe to Our Youtube Channel
Related Manuals for Cole Parmer SC-200 Series
Summary of Contents for Cole Parmer SC-200 Series
- Page 1 Cole-Parmer ® SC-200 Series Sample Concentrator Instruction Manual TECH0002 Version 1.1...
-
Page 2: Table Of Contents
Contents Introduction General Description Important Safety Advice Installation Operation Preparation Processing of Samples Maintenance Cleaning and Care Carriage Friction Replacing Sealing Pad In Case of Contamination Service and Repair Warranty Replacement Parts and Accessories Diagram of Gas Chamber Technical Specification Customer and Technical Support Solvent Evaporation Temperatures... -
Page 3: Introduction
Introduction Thank you for purchasing this Cole-Parmer product. To get the best performance from the equipment, and for your own safety, please read these instructions carefully before use. Before discarding the packaging check that all parts are present and correct. When unpacking the unit, check that the following have been removed from the packing: Base board ❖... -
Page 4: Installation
Installation For packing purposes the Sample Concentrator is supplied unassembled in three parts; the base board, the column and carriage, and the gas chamber. The unit is re-assembled as follows: 1. Unscrew the column fastening knob from the column support bracket already fixed to the base board. Locate the column on the two pins in the support bracket. -
Page 5: Operation
Operation Preparation ® 1. Place the aluminium insert blocks to be used into the Dri-Block unit. The blocks should touch each other and be positioned centrally. 2. Loosen the locking knob on the carriage. Remove the gas chamber, disconnecting the gas pipe if necessary, and lay the chamber upside down on a suitable work surface. - Page 6 SC-200 matrix plate SC-200-96 matrix plate Inserting the Needles...
-
Page 7: Processing Of Samples
Processing of Samples Warning - remember high temperatures are dangerous. The heater, insert blocks, sample vessels, needles and samples may be very hot. Always take the precautions listed earlier in this manual. 1. By turning the carriage handle, on the right hand side, counter clockwise raise the gas chamber to take the needles well away from the heater. -
Page 8: In Case Of Contamination
Replace the sealing pad with the new one. Reassembly is the reverse of the above procedure. ❖ In Case of Contamination WARNING: THE FOLLOWING PROCEDURE IS INTENDED AS A GUIDE. SHOULD SPILLAGE OF A TOXIC OR HAZARDOUS FLUID OCCUR, THEN ADDITIONAL SPECIAL PRECAUTIONS MAY BE NECESSARY. -
Page 9: Replacement Parts And Accessories
caused by installation, adaptation, modification or fitting of non-approved parts. Replacement Parts and Accessories The following replacement parts and accessories may be obtained from your supplier or from Cole-Parmer. Part Number Description F7209 Pack of 100 x 76mm long needles F7210 Pack of 100 x 127mm long needles FSC4NCS... -
Page 10: Technical Specification
Technical Specification Maximum vertical travel 320 mm Maximum gas pressure 2 psi Maximum gas usage 15 litres/min Any inert gas (often nitrogen) ® Needle positions Variable to suit Cole-Parmer Dri-Blocks Gas intake nozzle diameter 6.35 mm (¼") Height 530 mm Width 240 mm Depth... -
Page 11: Solvent Evaporation Temperatures
Solvent Evaporation Temperatures Boiling point (°C) at Pressure (mbar) at IUPAC Name Common Name 1013 mbar pressure which b.p is 40 °C 2-Propanone Acetone 1-Pentanol Pentyl alcohol Benzene Benzene 1-Butanol Butyl alcohol 2-Methyl-2-propanol Tert-butyl alcohol Chlorobenzene Chlorobenzene Chloroform Trichloromethane Cyclohexane Cyclohexane Ethoxyethane Diethyl ether... - Page 12 NOTES...
- Page 13 NOTES...
- Page 14 NOTES...
- Page 15 This product meets the applicable CE Directives that interference will not occur in practise. Where and UKCA Legislation for radio frequency there is a possibility that injury, damage or loss might interference and may be expected not to occur if equipment malfunctions due to radio interfere with, or be affected by, other equipment with similar frequency interference, or for general advise before qualifications.
- Page 16 Ordering Information Order No. Series Model Legacy SKU 36620-40 SC-200 SC-200 FSC400D 36620-41 SC-200 SC-200-96 FSC496D India Warranty Registration T: +44 (0) 1480 272279 T: +9122 61394444 E: uk.sales@antylia.com E: info@coleparmer.in W: coleparmer.co.uk W: coleparmer.in Germany China T: +49 (0) 9377 92030 T: +1 847 549 7600 E: de.sales@antylia.com E: sales@antylia.com...
Need help?
Do you have a question about the SC-200 Series and is the answer not in the manual?
Questions and answers