Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for BE BE12000ES
Summary of Contents for BE BE12000ES
- Page 1 GENERATOR BE12000ES User Manual BEPOWEREQUIPMENT...
-
Page 2: Table Of Contents
TABLE OF CONTENTS TABLE OF CONTENTS Introduction Operation Using the Operators Manual 20 Using Electric Power Registering Your Product 20 AC Application Wattage Reference Guide 21 DC Application Wattage Reference Guide 21 Connection of Cable Safety 21 Safety Precautions While Charging Safety Rules 22 Wattage Information Hazard Symbols and Meanings... -
Page 3: Introduction
The operating manual is an important part of your generator. It should *Air Conditioner 6000 Hand Drill 250 - 1100 be read thoroughly before initial use, and referred to often to make sure (40,000 BTU) adequate safety and service concerns are being addressed. Battery Charger Iron... -
Page 4: Safety
Follow the safety warnings to avoid any potential injury and damage to or see carbon monoxide. Even if you can’t smell exhaust fumes, you the device or other property. may still be exposed to carbon monoxide. • NEVER operate the generator in an explosive atmosphere, near Hazard Symbols and Meanings combustible materials or where ventilation is not sufficient to carry away exhaust fumes. -
Page 5: Ground Fault Circuit Interrupter Protection
• Fill the tank only on an area of bare ground. While fueling the tank, keep heat, sparks and open flame away. Carefully clean up any spilled A GFCI can be used only with generators that have the neutral wire fuel before starting engine. - Page 6 If generator has been covered to protect it is properly grounded. from the weather during non use, be sure to remove it and keep it well away from the area during generator use. This generator is equipped with a grounding terminal for added •...
-
Page 7: Generator Components
• The engine becomes extremely hot during and for some time after below. For specific model information, please visit: operation. Keep combustible materials well away from generator area. Be very careful not to touch any parts of the hot engine especially the muffler area or serious burns may result. BEPOWEREQUIPMENT •... -
Page 8: Preparing The Generator
10 feet can be used as a grounding source. If a pipe is unavailable, an 8 foot length of pipe or rod may be used as the ground source. The pipe should be 3/4” diameter or larger and the outer surface must be noncorrosive. -
Page 9: General Recommendations
WARNING When listening to a radio near the generator, the radio sound may be disturbed on account of the radio wave conditions and the radio performance from the generator. DO NOT overfill the tank, leave room for the fuel to expand. -
Page 10: Electric Start
CAUTION 7. Test the GFCI receptacle on the unit. Push the test button. The reset button should pop out and there should be no power at the receptacle. Do not connect appliances with defective power cords and/or plugs. Apply a test load or lamp to each receptacle to verify. IF THE RESET •... -
Page 11: Operation
3. Insert the plug(s) of the electrical appliance(s) into the receptacle. quantities of water and consult a doctor for treatment. • Be sure that the total wattage of all connected appliances does not exceed the rated output of the generator. -
Page 12: Wattage Information
They need 3 to 5 times the normal running wattage in order to start. For example, a 5000 watt generator would only be able to 2. The spark arrester must be free of breaks and holes. Replace the drive a 1000 to 7000 watt pump. -
Page 13: Stopping The Generator
1. Load is too high. 1. Reduce load. 2. Dirty air filter. 2. Clean or replace air filter. 3. Engine needs to be serviced. 3. Contact authorized service facility. Engine falters 1. Choke is opened too soon. 1. Move choke to halfway position until 2. -
Page 14: Maintenance
MAINTENANCE MAINTENANCE Maintenance Changing Engine Oil Change oil after the first 20 hours of operation. Thereafter it should be CAUTION changed every 100 hours. This generator uses SAE 10W30 oil. Make sure the engine is stopped before starting any maintenance, 1. -
Page 15: Maintenance Schedule
CLEAN GENERATOR. frequently when operating under heavy loads or in high temperatures. 6. Pull recoil starter handle until resistance is felt, leaving handle in that The air filter will need to be changed more frequently in dusty or dirty position. conditions. - Page 16 THE POWER YOU NEED. If you need assistance with the assembly or operation of your Generator please call 1 - 866 - 850 - 6662...
Need help?
Do you have a question about the BE12000ES and is the answer not in the manual?
Questions and answers