Balboa 300F Manual

Manual to Balboa series
For systems with v41 software
Display
Opstart
When you turn on your outdoor spa, the display enters "Priming
Mode" ( )
During Priming Mode, press the pump button repeatedly to
ensure that the pump is empty of air pockets.
Priming Mode lasts less than 5 minutes. Press the up or down
arrow to cancel Priming Mode.
After Priming Mode, the spa goes into Standard Mode (see
section Mode).
Temperature control (26 ° C - 40 ° C)
The display shows the last measured water temperature. The
current temperature is only displayed when the pump has been
running for at least one minute.
Press the up or down button once to display the set tempera-
ture. To change the set temperature, press the button again
before the display stops flashing. Each press of the up or down
button changes the temperature by one degree.
After three seconds, the display stops flashing and shows the
current temperature again.
Pumps
Press the pump button to turn the pump on or off. Press again
to get the pump at high speed.
The pump will run for a predetermined period, which can be as
long as two hours at low speed.
If the pump switches on automatically at low speed, the pump
cannot be switched off on the display. High speed can be
turned on or off. If an ozonator is installed, it will run while the
pump is operating at low speed. Circulation for filtration and
heating also runs at low speed.
If the buttons are pressed too quickly, the display may not de-
tect the subsequent presses.
DANSK BAD EM ILJØ
Pumps Lower Raise
Lightning
Lighting
Press the light button to turn the light on / off. It will automati-
cally turn off after four hours.
Mode
Depending on the configuration of your spa, you can run
several modes (modes) on your outdoor spa. If your spa cannot
switch modes, it will run in Standard Mode, indicated by
the display.
To switch, press an up or down button and then the light
button.
In Economy Mode, the spa only heats up to the set temperature
during the filtration cycle (low speed). It says
and the displayed temperature is not current but changes to the
water temperature during the cycle.
In Sleep Mode, the spa heats up to 10 ° C during the filtration
cycle. It says in the display and the displayed temperature is
the water temperature during the cycle.
Preset filtering cycles
The first preset filtration cycle begins 6 minutes after the spa is
turned on.
The next cycle begins 12 hours later.
Filtration cycles can be programmed for 1 - 8 hours in hourly
intervals. Default is one hour.
To set the cycle, first press the up or down key, and then the
pump button. Then use the up or down keys to set the time and
press the pump button to exit.
on
in the display
1