aquaforte FP Series Owner's Manual

IF THE PUMP CEASES TO FUNCTION, CHECK FOLLOWING:
• Check the switch/circuit breaker and try another socket in order to check that the pump has electricity
supply. N.B.: Always disconnect the power before handling the pump.
• Check that the hoses or the out ow are not blocked. A garden hose can be used to ush out any algae.
• Check the lter inlet and clear possible dirt.
• Remove the pump inlet in order to come to the rotor. Check that it is not broken or blocked.
If the pump is maintained monthly the length of life will be extended.
N.B.: Ensure that a part of the cable hangs lower than the socket. This prevents water running down
the cable into the socket.
WINTER MONTHS
• Protect your pump against frost.
• Take your pump from the water for the frost period.
• Clean the pump when necessary as previously described in the directions for use.
• Keep your pump, for example, in a bucket of water or a frost-free place so they can freeze or dry out.
LIMITED WARRANTY:
This product is guaranteed for a period of 12 months from date of purchase for material or
manufacturing defects. In case it is submitted for repair the pump must be with the original receipt.
Guarantee consists in guaranteed substitution of defective parts. Guarantee is considered to void in
case of improper use,or damages caused by improper handling or negligence on the part of the buyer.
All equipment must be sent postage paid
AquaForte is a trademark of Sibo BV, Doornhoek 3950, 5465TC, Veghel, Nederland
Email:info@sibo.nl Website: www.aqua-forte.nl
OWNER'S MANUAL
FP-SERIES FOUNTAIN PUMPS
Introduction
The pumps are carefully inspected and tested to ensure both safety and operating performance.
However, failure to follow the instructions and warnings in this manual may result in pump's
damage and/or serious injury. Be sure to read and save this manual for future reference.
Important!
The plug and the socket must not come in to contact with the water
If their is a problem with electrical supply to the pump resulting in its failure to operate, ensure it is
checked and repaired if necessary by a quali ed electrician. Ensure the electrical cable loops below the
electrical supply to form a "Drip Loop". The pump must be fully immersed in water when it is used, since dry
running can cause it to fail. Before the turning on the power ensure the pump is totally immersed in water.
Ensure that the electrical cable does not lie across pathways so that people do not trip on them.
Never leave the pump unattended during use if there are children nearby. Unplug the mains power when
the pump is not in use. Product is designed for use indoors or outdoors.
The cable cannot be replaced. If the cable is damaged the device must be discarded.