Related Manuals for Catler MF 610
Summary of Contents for Catler MF 610
- Page 1 Instructions for use MILK FROTHER Návod k obsluze PĚNIČ MLÉKA Návod na obsluhu NAPEŇOVAČ MLIEKA Használati útmutató TEJHABOSÍTÓ Instrukcja obsługi SPIENIACZ DO MLEKA Инструкции по эксплуатации МОЛОКОВЗБИВАТЕЛЬ MF 610...
- Page 2 MILK FROTHER...
-
Page 3: Table Of Contents
TABLE OF CONTENTS Catler recommends safety first Know your milk frother MF 610 Operating your milk frother MF 610 Care and cleaning Troubleshooting TABLE OF CONTENTS... - Page 4 Congratulations on the purchase of your new MF 610 milk frother. CONGRATULATIONS...
-
Page 5: Catler Recommends Safety First
CATLER RECOMMENDS SAFETY FIRST We understand the importance of safety and that’s why we put your safety first from the initial design concept to the production itself. Nevertheless, we ask you to be careful when using electrical equipment and to observe the following guidelines: •... - Page 6 • The milk jug may only be operated with the frother base supplied with the jug. Do not use either the jug or the frother base with other appliances unless otherwise specified by the manufacturer. CATLER RECOMMENDS SAFETY FIRST...
- Page 7 If you will not be using the appliance for a long period of time or if you leave it unattended, unplug the power cord from the power outlet. • Allow the appliance to cool down between frothing processes. CATLER RECOMMENDS SAFETY FIRST...
- Page 8 All repairs or adjustments must be performed at the nearest Catler authorised service centre. • Any maintenance other than routine cleaning must be entrusted to an authorised Catler service centre. •...
-
Page 9: Know Your Milk Frother Mf 610
KNOW YOUR MILK FROTHER MF 610 1. Jug lid with silicone seal 2. Jug for milk whisking 3. Jug handle 4. Heating element 5. Frother base 6. Control button – used to select the heating method 7. Frothing attachment for milk whisking 8. -
Page 10: Operating Your Milk Frother Mf 610
OPERATING YOUR MILK FROTHER MF 610 BEFORE FIRST USE WARNING! Before first use, remove all packaging and advertising labels / stickers from the FROTHING AT- appliance. TACHMENTS – RISK Wash the jug, lid and frothing attachments OF SUFFOCATION!! in warm water with a little dishwashing detergent and wipe dry. - Page 11 NOTE: of food such as chocolate chips, ground The frothing attachment can be very nuts, spices, fresh herbs, etc. hot. Wait for it to cool before removing it from the shaft. OPERATING YOUR MILK FROTHER MF 610...
- Page 12 NOTE: The temperatures and heating times are indicative only. The actual temperature and heating time depend on several factors such as the initial temperature of the milk, the quantity, the type of milk, etc. OPERATING YOUR MILK FROTHER MF 610...
- Page 13 The Cold function (stirring cold) is ideal for preparing cold drinks or dissolving ingredients. However, do not add powdered sugar-based ingredients. Frostings or syrups are most suitable. OPERATING YOUR MILK FROTHER MF 610...
-
Page 14: Care And Cleaning
CARE AND CLEANING Before cleaning the appliance, always JUG AND FROTHING ATTACHMENTS disconnect the plug of the power cord from Both the jug and the frothing attachment the mains socket and let it to cool down will be very hot after use. Wait for the jug and properly. -
Page 15: Troubleshooting
TROUBLESHOOTING This chapter describes the most common problems you may encounter while using this appliance. If your problem is either not stated here or persists, stop using the appliance, unplug the power cord and contact your authorized service centre. UNDER NO CONDITION SHOULD YOU REPAIR OR DISASSEMBLE THE APPLIANCE YOURSELVES. - Page 16 INSTRUCTIONS AND INFORMATION ON DISPOSING OF USED PACKAGING MATERIALS Dispose of used packaging material at a site designated for waste in your municipality. DISPOSING OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT This symbol on products or original documents means that used electric or electronic products must not be added to ordinary municipal waste.
- Page 17 NOTES...
Need help?
Do you have a question about the MF 610 and is the answer not in the manual?
Questions and answers