i-PRO WV-CF5SA Operating Instructions

Operating Instructions
Included Installation Instructions
Dome Cover
WV-CF5SA
Model No.
• Before attempting to connect or install this product, please read these instructions carefully and
save this manual for future use.
• The external appearance and other parts shown in this manual may differ from the actual product
within the scope that will not interfere with normal use due to improvement of the product.
i-PRO Co., Ltd.
https://www.i-pro.com/
© i-PRO Co., Ltd. 2022
Preface
This smoke type dome cover is used to install the indoor use dome-type monitoring camera.
For the latest information about the supported cameras, refer to our support website
(https://i-pro.com/global/en/surveillance/training_support/support/technical_information<Control
No.:C0501>).
Specifications
Ambient operating temperature: –10 °C to +50 °C {14 °F to 122 °F}
Dimensions: Diameter
Height
Diameter of the dome : 40.1 mm {1-19/32 inches}
Approx. 25 g {0.06 lbs}
Mass:
Finish: Acrylic resin, Smoke (transparency: approx. 30 %)
Precautions
„ Refer installation work to the dealer.
Installation work requires technique and experience. Failure to observe this may cause fire, electric
shock, injury, or damage to the product.
Be sure to consult the dealer.
Standard Accessories
Operating instructions (this document) .......................................................................................1 pc.
N0521-1042 PGQX2454YA
: 92 mm {3-5/8 inches}
: 49.3 mm {1-15/16 inches}
Installation
Read the following descriptions together with the Installation Guide of the camera.
Note:
• When a smoke type dome cover is used, the IR LED irradiation distance and the illuminance
level are lower than for a standard clear type dome cover.
Check the settings after attaching the enclosure.
Step1
Step2
Dustproof sheet fixing screw (2 pcs.)
Dustproof sheet
Note:
• The dome cover is locked using the enclosure
hooks (3 parts). Remove one hook at a time
while pushing the dome cover inwards.
Step3
Dustproof sheet
→Step 2
WV-CF5SA
Dome cover
(smoke)
Step4
After installation is complete, attach the enclosure to the camera.
The Installation Guide of the camera.
https://i-pro.com/global/en/surveillance/documentation_database
IMPORTANT:
• When the enclosure is attached, the camera's focus may go out of focus. Use the "Auto focus"
function in the setup menu to adjust the focus.
• Remove the cover film after installation is complete.
• Use lens cleaning paper (used to clean camera or spectacles lenses) to remove any dirt or
fingerprint on the dome cover.
Enclosure fixing screw
(2 places)
Dome cover
Dustproof sheet fixing screw (2 pcs.)
→Step 2
0.24 N·m
{0.18 lbf·ft}
Note:
• Remove the protection film of
WV-CF5SA once. After replacing
the dome cover, attach it again.
• When replacing the dome cover,
be careful not to scratch the
outside or inside of the dome
cover.