Build your own oscilloscope and learn how to visualize signals. See the signals you learn about in real life!
Despite the low cost, this oscilloscope has a lot of features found only on expensive units like signal markers,
frequency, dB, true RMS readouts,... A powerful auto-setup function will get you going in a snap!
Note: This scope cannot be used to perform measurements on voltages higher than 30Vpp.
Educational
Timebase range: in 15 steps,
10µs/division to 500ms/division.
Full auto set up for: Volt/div and time/div
(or manual).
Readouts: DC, AC+DC, true RMS, dBm,
Vpp, min. & max.
Maximum input voltage: 30Vpeak
(AC + DC).
Maximum sample rate: 1MS/s for repetitive
signals. Measurements can be performed
up to 100kHz.
Input sensitivity range: in 6 steps,
100mV/division to 5V/division.
Input coupling: DC and AC.
Time and voltage markers readout.
Battery operated: 4 x AAA batteries
(max. 100mA).
LED backlight LCD.
Dimensions:
80 x 115 x 40mm / 3.14 x 4.52 x 1.57"
- 4 -