Table of Contents
Advertisement
Construction
17
Mounting the test leads
STEP 1: Strip both cables and twist the wire
ends of each cable.
STEP 2: Thin the wires.
STEP 3: Mount both cables as shown in the
drawing.
-
Tip:
Start with one cable and then do
the other.
+
Step 4: Solder the cables on the PCB.
18
Mounting the battery holder
STEP 1: Stick one part of the included hook-and-loop strap (hooks)
on one of the long sides of the battery holder.
STEP 2: Connect the battery holder to the base
PCB using the included red and black mounting
wires. Mind the polarity!
• Red
= +
• Black = -
- 10 -
Advertisement
Table of Contents
