System Memory Support; Memory Configurations: Ultra Slim Desktop - HP Compaq Elite 8200 CMT Specifications

QuickSpecs
Standard Features and Configurable Components (availability may vary by country)
will be displayed as such in the RAID option ROM interface.
Hard drive information can be viewed within F10 Setup while in RAID mode. Previously, the hard drives will not appear in
Drive Configuration when switching to RAID mode.
DPS Self Test can be executed on physical hard drives while in RAID mode.
The RAID Setup Utility (accessed through CTRL-I) can be protected by the F10 Setup password.
NOTE: NOTE: NOTE: NOTE:
RAID 1 is the only RAID configuration offered via factory configurations. The pre-configured systems:
Are only available on the SFF and CMT form factors. The USDT does not support RAID as it does not allow for more than one
hard disk drive.
Are complete RAID systems and have both drives installed. If the CMT is configured with three hard disk drives, the third drive
is would be unpartitioned and not part of the RAID array
Have the necessary Option ROM configuration.
Are pre-loaded and pre-installed with all required Intel software.
Include a preinstalled operating system that is mirrored mode out of the box.
Please refer to the HP White Paper titled "Advanced Host Controller Interface (AHCI) and Redundant Array of Independent Disks
(RAID) on HP Compaq 8200 Elite Series PCs" at:

System Memory Support

System Memory Support System Memory Support System Memory Support
The HP Compaq 8200 Elite Series supports the 2
architecture, the processor is designed for a two-chip platform consisting of a processor and Platform Controller Hub (PCH). Unlike
previous generations, the processor includes an integrated memory controller (IMC). The IMC supports DDR3 protocols with two
independent, 64-bit wide channels each accessing one or two DIMMs.
Two channels of non-ECC unbuffered DDR3 memory with a maximum of two UDIMMs or SODIMMs per channel
Single-channel and dual-channel memory organization modes
Data burst length of eight for all memory organization modes
DDR3 memory data transfer rates of 1066 MT/s (PC3-8500) and 1333 MT/s (PC3-10600)
64-bit wide channels
DDR3 I/O voltage of 1.5V
Maximum memory bandwidth of 10.6 GB/s in single-channel mode or 21 GB/s in dual-channel mode assuming DDR3 1333
MT/s (PC3-10600)
1GB, 2GB, and 4GB DDR3 DRAM technologies are supported. Using 4 GB device technologies, the largest memory capacity
possible is 32 GB, assuming dual channel mode with four x 8 GB dual ranked unbuffered DIMM memory configuration.
CAUTION: You must shut down the computer and disconnect the power cord before adding or removing memory modules.
Regardless of the power-on state, voltage is always supplied to the memory modules as long as the computer is plugged in to an
active AC outlet. Adding or removing memory modules while voltage is present may cause irreparable damage to the memory
modules or system board.
Memory Configurations: Memory Configurations:

Memory Configurations: Ultra Slim Desktop

Memory Configurations:
Slot 1 is black and must always be populated. Not all memory configurations possible are represented below.
NOTE: NOTE: NOTE: NOTE:
For systems configured with more than 3 GB of memory and a 32-bit operating system, all memory may not be available due to
system resource requirements. Addressing memory above 4 GB requires a 64-bit operating system
http://www.hp.com
nd
generation Intel® Core™ processor family. Based on a new PC micro-
Ultra Slim Desktop Ultra Slim Desktop Ultra Slim Desktop
DA - 13879 North America — Version 10 — June 13, 2011
HP Compaq 8200 Elite Series HP Compaq 8200 Elite Series HP Compaq 8200 Elite Series HP Compaq 8200 Elite Series
for more information and instructions.
Page 9