System Board - HP Compaq dx2000 ST Series Reference Manual

Removal and Replacement Procedures— Slim Tower (ST) Chassis

6.11 System Board

1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove all PCI expansion boards
4. Disconnect all cables connected to the system board, noting their location for reinstallation.
5. Compress the system board tray handle 1 to release the latch and slide the system board tray
towards the front of the computer 2 to free it from the back of the chassis.
To install the system board, slide the tray assembly into the chassis and press down on the two
places shown in the drawing 1 while sliding the tray into its locked position 2.
6–22
(Section 6.1, "Preparation for
(Section 6.3, "Computer Access
(Section 6.7, "PCI Expansion
371411-001
Disassembly").
Panel").
Card").
Service Reference Guide, dx2000 ST