Speaker - HP Compaq dx2000 ST Series Reference Manual

Removal and Replacement Procedures— Slim Tower (ST) Chassis

6.16 Speaker

1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Rotate the drive cage to its upright position.
4. Disconnect the speaker wire from the system board.
5. Carefully cut the cable tie that secures the speaker cable to the power supply cable bundle.
CAUTION: Be careful when cutting the cable tie not to cut any cables.
Ä
6. Remove the power supply from the chassis
7. Remove the two screws that secure the speaker to the chassis 1.
8. Slide the speaker towards the rear of the chassis and down to remove it 2.
To install the speaker, reverse the removal procedures.
6–30
(Section 6.1, "Preparation for
(Section 6.3, "Computer Access
(Section 6.17, "Power
371411-001
Disassembly").
Panel").
Supply").
Service Reference Guide, dx2000 ST