Page 1
The right to change the design and specifications reserved. The trademark, patent and copyright are owned by Steelmate Co., Ltd. STEELMATE CO., LTD Steelmate Industrial Park, Heping Street, Dongfu Road, Dongfeng Town, Zhongshan City, Guangdong, P.R. China 528425 Manual PRI0775/A...
2. Unit should be installed by a professional auto All weather design (-40°C~+85°C/-40°F~+185°F) your region. technician. PTS400W1/PTS400Q1/PTS400Q4/PTS400T is a 4-sensor rear wireless parking assist system, from 3. Route wiring harness away from heat sources control unit to buzzer/display is wireless.
Number of damaged sensors PTS400T Sensor A has problem(E1:1 damaged sensor) Sensor A,D have problem (E2: 2 damaged sensors) PTS400W1 Once the reverse gear is engaged, press and hold " " button for 2 seconds to turn on/off the voice alarm...
Page 6
PTS400T PTS400W1 The system will test all the sensors when the reverse gear is engaged. The system will test all the sensors when the reverse gear is engaged. If all the sensors are working normally, the system will beep once and the LCD display will flash once.
Attention Sensor maintenance How does the system work False detection may occur in the following PTS400W1 & PTS400Q1 & PTS400Q4 situations: Do not wash the sensor with a pressure washer of scrub them forcibly. Matrix zone Buzzer Please wash car with low- pressure water.
Page 8
PTS400T Distance: >2.5m/8.2ft Distance: 2.5m/8.2ft ~1.5m/4.9ft Distance: 1.5m/4.9ft ~ 1.0m/3.3ft Distance: 1.0m/3.3ft ~ 0.6m/2.0ft Distance: 0.6m/2.0ft ~ 0.3m/1.0ft Distance: < 0.3m/1.0ft The obstacle distance is >2. The obstacle distance is 2.5m/8. The obstacle distance is 1.5m/4.9ft The obstacle distance is: 1.0m/3. When the obstacle distance is When the obstacle distance is 5m/8.2ft, the white backlight...
Packing list PTS400Q4 PTS400Q1 PTS400T PTS400W1 Installation Manual The actual sensor may vary from the image shown above Installation tools 45' ~ 60'...
Sensor installation Pls adjust the sensor angle according to sensor height and bumper angle, avoid detecting to ground. H > 0.45m/1.5ft H < 0.65m/2.1ft < 0.45m/1.5ft < 0.45m/1.5ft < 0.45m/1.5ft H < 0.45m/1.5ft H > 0.65m/2.1ft Check the size of the hole saw packed in the product matches = 1/8L = 2/8L the diameter of the sensors before drilling any holes.
Function testing Wiring diagram Reversing light PARKING ASSIST SYSTEM Display Buzzer Black Function test is performed by holding a wooden board (0.3 x 1m/1.0 x 3.3ft) standing at the back of the car, and reverse the car slowly to test each function respectively as shown in this manual.
Troubleshooting After installation, the buzzer & display doesn’t 2) Replace the ECU and recheck the system. work 3) Plug the certified sensors into the ECU and a) Are all wires connected properly? recheck. b) Is the vehicle’s ignition ON? 4) Email your question to us and we will reply c) Is the reversing gear engaged (the reversing ASAP.
Need help?
Do you have a question about the PTS400W1 and is the answer not in the manual?
Questions and answers