Advertisement
Before Use
Dehumidfying Mode
1. Press "POWER" key to turn on the dehumidifer,
2. LED displays the ambient humidity
3. In the first time, the mode will base on current humidity to change the fan speed automatically. And set
the swing angel as the maximum
4.
If it is not the first time, press "DEHUMIDFY MODE " key until
5. Press "FAN SPEED" key to select fan speed
Medium
High
6. Press "SWING" key to select vertical louver swing angle
Air Flow
Front-up
Remarks ：
1 : When choosing different angle of the louver, louver will be swing to the largest angle for 10 seconds first, and then move to the
selected option.
2: Press the Air flow icon again, louver will stop as is.
7.Timer setting
Press "TIMER" to set the dehumidifying duration. The"hr"on the display top left corner will flash
Press the "TIMER" or "HUMIDITY" key to select the duration with sequence 1 -> 2 -> 3-> ......>23->
24-->CO(CONTINUOUS). The dehumidifer will stop when the time is up.
8.Humidity setting
Press "HUMIDITY" to set the desire ambient humidity(RH%). The "%" on the
will flash
, by pressing the "HUMIDITY" or "TIMER" key to select the humidity. "TIMER"
increases the RH% with sequence 40% -> 50% -> 60% -> 70% -> 80% -> -- (continuous) and
"HUMIDITY" in decreasing sequence 80% -> 70% -> 60% -> 50% -> 40% -> -- (continuous), 5
seconds later, display will show the current ambient humidity. When the ambient humidity is lower
than s elected humidity, t he display will show the current ambient humidity. At that moment, the
compressor will stop operation. But the fan will keep operating . The machine will stop automatically
when the ambient humidity is lower than 30%.
9. Press "POWER" to stop the machine, it will continue to operate for 1 0 seconds. Then, it will stop
operation . (For details of 'INTERNAL DRYING ", please refer to P.47)
CAUTION
Machine will stop operation under following situation:
•When the water tank is full (P.42)
•When the temperature or humidity is out of operation range ( P . 3 7)
•Press "CO"(continuous), the unit will stop automatically after 48 hours operation. If water tank was
taken out during operation , the counting time will start over again.
•When the unit is off, the user can pre-set the operation time. For example, press 01, the unit will
turn on automatically after 1 hour .
38
lights up
Low
Front-down
lights up.
display
top right corner
,
Advertisement
