Table of Contents
Advertisement
9. Install the units from the SLIP 2 WASHER to REEL
BELT shown in the Fig. 2-14-1.
Note1 : Be sure to replace the removed PULLEY BUSH
with a new one.
Note2 : Attach the SLIP SPRING with its straight end
facing the SLIP GEAR side.
Note3 : Attach the SLIP 2 WASHER with its position set
as shown in the Fig. 2-14-5.
Note4 : Apply GREASE (PG-641) [859D055O30] to the
part on the SLIP 2 WASHER specified in the Fig.
2-14-5.
10. Install the SHIFT SLIDER to the SHIFT LEVER shown
in the Fig. 2-14-1.
Match the Lug of the
IDLER UNIT
SLIP ADJUSTER with
the Center Notch of
the IDLER UNIT.
PULLEY GEAR ASSY
[SLIP GEAR side]
Straight end
[THRUST WASHER side]
Apply GREASE (PG-641) to the parts
- 10 -
SLIP ADJUSTER
Center of the
BELT PULLEY
Apply GREASE
(PG-641)
to the parts
Fig. 2-14-3
Felt Side
SLIP GEAR
Grooved Side
Fig. 2-14-4
SLIP SPRING
SLIP 2 WASHER
.
Fig. 2-14-5
.
Advertisement
Table of Contents
