Advertisement
STEP 2 - ATTACH BEAM CONNECTOR PLATES AT EACH END OF THE BEAMS.
THREAD THE LARGER HEX HEAD 5/16-18 X 3/4" BOLTS (Item 3) WITH 1/4"
FLAT WASHERS (Item 2) THROUGH THE HOLES AT THE ENDS OF THE BEAMS
A FEW THREADS INTO THE BEAM CONNECTOR PLATES. THESE MUST BE
LOOSE AT THIS TIME. (SEE FIGURE 3)
STEP 3 - INSTALL THE PEDESTAL LEGS. ( Item 5 )
THE PEDESTAL LEGS HAVE SLOTS AT THE TOP, WHICH WILL FIT OVER THE
BOLTS HOLDING THE BEAM CONNECTOR PLATES TO THE SUPPORT BEAMS.
SLIDE THE LPEDESTAL LEGS OVER THE BOLTS SO THAT THE CONNECTOR
PLATE IS INSIDE THE LEG TUBE. (See Figure 4) TIGHTEN THE BOLTS SO
THEY ARE "SNUG"...DO NOT TIGHTEN COMPLETELY. THERE ARE TWO
INSERTS IN THE WORKSURFACE THAT LINE UP WITH OBLONG SLOTS IN
EACH OF PEDESTAL LEG TOP BRACES. THREAD THE SMALLER HEX HEAD
1/4 -20X3/4 BOLTS (Item 1) WITH 1/4 FLAT WASHERS (Item 2) INTO THE
INSERTS FOR BOTH PEDESTAL LEGS. THE FRAME MUST BE SQUARED UP
ON THE WORKSURFACE (See Figure 2). ONCE THE FRAME IS SQUARED ALL
HARDWARE MUST BE TIGHTENED COMPLETELY. CAUTION: DO NOT OVER
TIGHTEN THE BOLTS ATTACHING THE FRAMES TO THE WORKSURFACE AS
THIS MAY CAUSE DAMAGE TO THE WORKSURFACE.
Figure 2
4
Advertisement
