Before Commissioning - Kärcher B 95 RS Manual

Before Commissioning

Pushing the device
While standing, the device is protected
against rolling off with the help of an electri-
cal immobilising brake. To push the de-
vice, you need to first unlock the immobilis-
ing brake.
 Pull the unlocking lever to unlock the
parking brake.
ATTENTION
Risk of damage. Do not push the device
faster than 7 km/h.
Unloading
Note:
Take the foot off the accelerator pedal and
press the emergency-stop pushbutton to
immediately switch off all functions.
 Remove the cardboard.
 Loosen the fixing at the wheels.
 Create ramp by repositioning the pallet
as shown above and screwing it togeth-
er.
 Pull the brake lever and push the appli-
ance down the ramp with the level
pulled.
or
 Plug in the Intelligent Key.
 Release emergency-stop button by
turning.
 Set programme selector switch to trans-
port run.
 Stand on platform and operate safety
switch.
 Set the travel direction switch to "for-
ward".
 Actuate the accelerator pedal.
 Drive the appliance off the pallet.
The brushes must be installed before the
initial operation (see "Maintenance work").
Batteries
Observe the directions on the bat-
tery, in the instructions for use
and in the vehicle operating in-
structions
Wear eye protection
Keep children away from acid and
batteries
Danger of explosion
Fire, sparks, naked flames and
smoking must be strictly avoided
Danger of chemical burns
First aid
Warning note
Disposal
Do not throw the battery into the
regular waste
DANGER
Risk of explosion!
Do not place tools or similar items on the
battery. Risk of short-circuit and explosion.
Risk of injury. Ensure that wounds never
come into contact with lead. Always clean
your hands after having worked with batter-
ies.
Recommended battery sets
170 Ah - mainte- 4.035-
nance-free 164.0
180 Ah - mainte- 4.035-
nance-free 097.0
180 Ah, - low 4.035-
maintenance 165.0
195 Ah - low 4.035-
maintenance 166.0
* Minimum volume of the battery charging
room
** Minimum air flow between the battery
charging room and the surroundings
4
-
EN
Insert batteries and connect
The "Pack" model contains built-in batter-
ies.
 Press emergency-stop button.
 Remove the Intelligent Key.
 Open the lock of the battery cover.
 Tilt the battery cover backwards.
1 Locking the battery insert
 Push the lock of the battery insert to-
wards the left and tilt it downward.
 Pull the battery insert towards the rear.
4.035.097.0, 4.035-165.0
1 Spacer 380x55x30
4.035-164.0
1 Spacer 345x60x47
2 Spacer 380x55x30
3,3 1,32
3,8 1,52
14,85 5,94
22,28 8,94
4.035-166.0
1 Spacer 380x55x30
ATTENTION
Risk of damage. Mind correct polarity.
 Connect pole using the enclosed con-
necting cable.
 Connect the connection cable to the
free battery poles (+) and (-).
19