Kärcher B 60 Quick Start Manual
  1. Manuals
  2. Brands
  3. Kärcher Manuals
  4. Scrubber
  5. B 60
  6. Quick start manual
Kärcher B 60 Quick Start Manual

Kärcher B 60 Quick Start Manual

Hide thumbs Also See for B 60:
1
2
3
4
5
6

Advertisement

Table of Contents

QUICKSTART
B 60

Start up

1
A
2
A
3
A
1
A
Warning
These are only brief instructions! Please read and comply with these instructions prior to using or servicing your
appliance.
The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers
for the operator and other persons.
B
B
B
B
A Unplug the charger from the mains.
B Wind the mains cable around the cable hold-
ers.
A Open the lock of the fresh water reservoir.
Fill fresh water (maximum 60 °C) until the
lower edge of the filling nozzle.
Close the lock of the fresh water reservoir.
or
B Connect the hose to the automatic filling
system and open the water supply
(max. 60 °C, max. 5 bars).
Model with dosing equipment "Dose"
A Place the detergent bottle into the holder.
Close the bottle lid.
Insert the suction hose of the dosaging
equipment into the bottle.
Model without dosing equipment "Dose"
B Add the detergent to the fresh water
reservoir.
Starting the machine
A Turn the program selection switch to "OFF".
B Plug in the Intelligent Key.
5.964-272.0 10/12

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B 60 and is the answer not in the manual?

Questions and answers

Related Manuals for Kärcher B 60

Summary of Contents for Kärcher B 60

  • Page 1 QUICKSTART B 60 Warning These are only brief instructions! Please read and comply with these instructions prior to using or servicing your appliance. The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers for the operator and other persons.
  • Page 2 QUICKSTART Operation Driving A Turn the programme selector switch to position 1 "Transport mode". B First select the driving speed at the rotary knob. Drive forward C Press the driving lever to the front. Stop the machine: Release driving lever. Reverse drive D Press the driving lever to the rear.
  • Page 3 QUICKSTART Finish operation Turn off the appliance A Close the regulatory button for setting the water quantity. B Release driving lever. C Set the program selection switch to suction or vacuuming. D Briefly drive forward and suck of the remain- ing water.

  • Page 4: Maintenance And Care

    QUICKSTART Maintenance and care A Remove the coarse dirt sieve from the wastewater reservoir and clean B Check the fluff filter, clean if re- quired. Warning Please observe the local provisions regarding the wastewater treatment. A Loosen the lid for emptying the fresh water - do not remove it fully.

  • Page 5: Troubleshooting

    QUICKSTART Troubleshooting Appliance cannot be started A Stand-by. Plug in the Intelligent Key. Turn the program selection switch to the desired programme. B Battery depleted. Charge battery. Insufficient vacuum performance A Clean the seals between dirt water reservoir and cover and check for tightness, replace if required.
  • Page 6 QUICKSTART Troubleshooting Brushes do not turn A If over-current switch in the electronics sys- tem has been triggered, turn programme se- lection switch to "OFF". Afterwards, set it back to the desired programme. B Check the brushes for blockage due to for- eign particles, remove them if found.

Table of Contents