Applications > Shock Detection - Vivotek Supreme FE9192-H User Manual

VIVOTEK
Applications > Shock detection
The camera comes with a shock accelerometer. The shock sensor can detect impacts to the
camera. For example, when a person deliberately tries to destroy the camera, the camera can
report the event to the administrator.
Normally, a 5kgm impact can cause the detected impact level to surge to 50% on the scale.
Configure the Alarm Level to a preferred percentage on the chart. Click the Enable shock
detector checkbox and click Save to complete the configuration.
You should then go to Event settings to configure the shock detection as a triggering source.
See page 119 for Event configuration.
The measurement range of the sensor is ±16G.
For every one G force (g = 9.8 m/s²) perceived, the sensor acquires a reading of 512.
The value acquired by a 2 G acceleration will look like the following:
512 * 2 /16 = 64
Suppose that all 3-axis readings are equal (for simplicity reasons only), the shock level shown
on the Shock detection chart will be (64 + 64 +64 ) *100 /1024 = 18.75.
142 - User's Manual
Shock Level