Table of Contents
Advertisement
WHOLE-HOME CLEANING
POWER SWITCH
Press power button to turn on vacuum.
Please note the brushrolls will not spin
unless the wand is reclined.
NOTE: Try using Hard Floor mode for low pile area rugs.
HEADLIGHT INDICATOR LIGHTS
HEADLIGHTS
The headlights will flash or turn red to
indicate issues that need attention.
Solid White Lights: The brushrolls are spinning and the unit is working as it should.
Solid Red Lights: There is a jam in the brushroll area. Turn off the vacuum and unplug it, then
remove any blockages in the nozzle.
Flashing Red Lights: The motorized floor nozzle is overheating. Turn off the vacuum, unplug
it, and remove any blockages. Let the vacuum cool down for at least 60 minutes before
restarting. See Troubleshooting section for more information.
Flashing White Lights: The vacuum is operating in an environment that is either too hot or
too cold. This vacuum will only function properly in temperatures ranging from 32°F (0°C) to
104°F (40°C). Turn the vacuum off and adjust the room temperature.
NOTE: For deep cleaning per ASTMF608 (embedded dirt in carpets), please set to Carpet/Low Pile mode.
NOTE: For maximum suction for above-floor cleaning per ASTM F558, set to Hard Floor mode.
s h a r kc l e a n . c o m
SETTINGS
SURFACE SELECTOR
Thick Carpet & Area Rug Cleaning
Slide the surface switch to the top position
to select Thick Carpet/Area Rug.
Carpet & Low Pile Cleaning
Slide the surface switch to the middle position
to select Carpet/Low Pile to increase the
speed of the brushrolls and to help remove
stuck-on dust and debris.
Hard Floor Cleaning
Slide the surface switch to the bottom
position to select Hard Floor.
WHOLE-HOME CLEANING
CLEANING MODES
UPRIGHT
To engage brushrolls, step on
floor nozzle and tilt handle back.
ABOVE-FLOOR—HANDLE
Press the Handle Release button to
detach the handle from the wand.
POWERED LIFT-AWAY®
Press the Lift-Away button to detach
the pod from the floor nozzle.
NOTE: All accessories are compatible with both the wand and the handle.
ABOVE-FLOOR—WAND
Press the Wand Release button to
detach the wand from the pod.
LIFT-AWAY®
With pod removed, press the
Wand Release button to detach
the wand from the floor nozzle.
s h a r kc l e a n . c o m
Advertisement
Table of Contents
