Trouble Shooting - Russell Hobbs RHTTLDR2 Instruction Manual

Trouble shooting

Problem Solution
Check that the appliance is switched on.
Check that there has not been a power cut.
Check that the plug is not faulty.
Check that the fuse has not blown.
The fridge doesn't work
Check that the voltage is correct for the appliance.
Are there any faults with the socket? For this purpose, try
the plug of your appliance by connecting it to a socket
which you are sure is working.
Check that there is not too much food in the appliance.
Check that the thermostat is set to a suitable
temperature.
Check that the appliance is not placed in direct sunlight,
or too near to a heating source.
The temperature inside the Check that the ambient temperature is within the
appliance is not cold enough operation limits of the appliance.
Are the doors of the appliance opened frequently? Once
the door is opened, the humidity found in the air in the
room enters the appliance, especially if the humidity
levels in the room are very high. The more frequently the
door is opened in humid conditions the more chance of
the build up of moisture.
Increase the working temperature by adjusting the
thermostat to a lower setting.
The temperature within the The highest setting should only be used as a rapid cool
appliance is too cold. setting and should only be set 2 hours before a large
amount of food is placed in the fridge. If this is not done
the temperature in the fridge compartment could fall
below 0ºC as the compressor will run continuously.
The inner surfaces of the
Caused by condensation - dry the inside of the appliance.
appliance are wet
The outer surfaces of the Caused by condensation - dry the outer of the appliance
appliance are wet carefully.
15