Table of Contents
Advertisement
3-7
Installing the Hard Disk Drive
Read the following guidelines before you begin to install the Hard disk drive:
• Take note of the drive tray orientation before sliding it out.
• The tray will not fit back into the bay if inserted incorrectly.
• Make sure that the HDD is connected to the HDD connector on the backplane.
Follow these instructions to install a 3.5" hard disk drive:
1.
Loosen the thumbscrew securing the left/right side chassis cover.
2.
Open the left/right side cover.
3.
Press the release button on the HDD tray.
4.
Extend the locking lever.
5.
Pull the locking lever in the direction indicated to remove the HDD tray.
6.
Align the hard disk drive with the positioning stud on the HDD tray.
7.
Slide the hard disk drive into the HDD tray.
8.
Reinsert the HDD tray into the slot and close the locking lever.
2
1
3
4
6
System Hardware Installation
- 34 -
1
5
7
Advertisement
Table of Contents
