Table of Contents
Advertisement
When you need to manually set up the connection
If the wireless router is set as described below, manually enter all the required information for the wireless LAN
connection (
Setting Up Connection by Specifying Detailed Settings(P. 31) ).
●
ANY connection refusal
●
The WEP key that was automatically generated (hexadecimal) is selected.
●
The stealth mode is activated.
*
A function in which the wireless router refuses the connection if the SSID on the device to be connected is set to "ANY"
or is blank.
When you need to change the settings of the wireless router
If the wireless router is set as described below, change the settings of the router.
●
The MAC address packet filtering is set.
●
When only IEEE 802.11n is used for the wireless communication, WEP is selected or the WPA/WPA2
encryption method is set to TKIP.
Problem with the USB Connection
Cannot communicate.
●
Change the USB cable. If you are using a long USB cable, replace it with a short one.
●
If you are using a USB hub, connect the machine directly to your computer using a USB cable.
Troubleshooting
●
Are there any appliances such as microwave ovens or digital cordless phones that
emit radio waves near the machine?
Perform one of the following settings again.
Setting Up Connection Using WPS Push Button Mode(P. 25)
Setting Up Connection Using WPS PIN Code Mode(P. 27)
Setting Up Connection by Selecting a Wireless Router(P. 29)
Setting Up Connection by Specifying Detailed Settings(P. 31)
*
is activated.
229
Advertisement
Table of Contents
