Table of Contents
Advertisement
Removing an Expansion Card
You might need to remove an expansion card to install a component on it, or to improve access to components on the
system board.
Removing a Card
1 Follow steps
2 Unscrew and remove the screw securing the card. Keep the screw.
3 Carefully remove the card from its connector, holding the card at each end by its top edge. If the card is tight, loosen
the screws on the adjacent slots. Do not bend the card. If you intend to replace the card later, note its position.
4 With its components facing up, place the card on a clean, flat, solid, static-free surface. Handle the card by its edges.
5 If necessary, install any components on the expansion card.
6 Replace the expansion card if necessary (refer to steps
not replace the card, remember to replace the slot's faceplate.
1
to
3
of
"Installing an Expansion Card" on page
51.
6
to
9
of
"Installing an Expansion Card" on page
3 Upgrading and Adding Accessories
Adding Accessories
51). If you do
55
Advertisement
Table of Contents
