Table of Contents
Advertisement
AXIS M3077-PLVE Network Camera
The device interface
Remote system log
Syslog is a standard for message logging. It allows separation of the software that generates messages, the system that stores
them, and the software that reports and analyzes them. Each message is labeled with a facility code, which indicates the software
type generating the message, and assigned a severity level.
Server: Click to add a new server.
Host: Enter the hostname or IP address of the server.
Format: Select which syslog message format to use.
• RFC 3164
• RFC 5424
Protocol: Select the protocol and port to use:
• UDP (Default port is 514)
• TCP (Default port is 601)
• TLS (Default port is 6514)
Severity: Select which messages to send when triggered.
CA certificate set: See the current settings or add a certificate.
Plain config
Plain config is for advanced users with experience of Axis device configuration. Most parameters can be set and edited from
this page.
Maintenance
Restart: Restart the device. This does not affect any of the current settings. Running applications restart automatically.
Restore: Return most settings to the factory default values. Afterwards you must reconfigure the device and apps, reinstall any
apps that didn't come preinstalled, and recreate any events and PTZ presets.
Important
The only settings saved after restore are:
• Boot protocol (DHCP or static)
• Static IP address
• Default router
• Subnet mask
• 802.1X settings
• O3C settings
Factory default: Return all settings to the factory default values. Afterwards you must reset the IP address to make the device
accessible.
Note
All Axis device firmware is digitally signed to ensure that you only install verified firmware on your device. This further
increases the overall minimum cybersecurity level of Axis devices. For more information, see the white paper "Signed
firmware, secure boot, and security of private keys" at axis.com.
46
Advertisement
Table of Contents
