Safety Warnings - HP b2600 Upgrade Instructions

Getting Started

Safety Warnings

Safety Warnings
WARNING Removing the device cover may expose sharp edges in the equipment chassis.
To avoid injury, use care when installing customer add-on devices.
NOTE Before performing removal/replacement procedures, position the workstation on a
cushioned flat, stable surface, such as a table top or workbench.
NOTE Installing the recommended HP replacement part in your B Class and C Class
workstation does not affect the regulatory and safety classifications or approvals listed
in the original owner's guide.
Electrostatic Discharge (ESD) Precautions
To prevent damage to the B Class and C Class workstation, observe all of the following
ESD precautions while performing removal and replacement procedures:
•
•
•
•
•
•
2
Remove all ESD-generating materials from the work area in which you will remove
and replace the workstation field replaceable unit(s).
Open the ESD materials provided with the replacement part kit. Unfold the black
conductive sheeting (antistatic mat) and place it under a corner of the workstation.
Wear a static strap to ensure that any accumulated electrostatic charge is
discharged from your body to ground. Attach the static-grounding wrist strap by
following the instructions on the package. Attach the sticky end of the wrist strap to
bare metal on the rear panel of the workstation.
Connect all equipment together, including the static-free mat, static strap, clips
attached to the wrist strap, nodes, and peripheral units.
Keep uninstalled printed circuit boards in their protective antistatic bags.
Once you have removed printed circuit boards from their protective antistatic bags,
handle the printed circuit boards by their edges only.
Chapter 1