Connecting Your Monitor - Iiyama G-MASTER GB2760QSU-B1 User Manual

CONNECTING YOUR MONITOR

Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the USB Cable.
Connect the Power Cable to the monitor first and then to the power source.
Turn on your monitor and computer.
NOTE
 The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama office.
 For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.
 Make sure you tighten the finger screws at each end of the signal cable.
 The Class I pluggable equipment Type A must be connected to protective earth.
 The socket-outlet shall be installed near the equipment and shall be easily accessible.
 Excessive sound pressure from ear-/headphones can cause hearing damage/hearing loss.
[Example of Connection]
Power Cable (Accessory)
[ Collect Cables ]
Put the cables through the cable hole to bundle them.
8 BEFORE YOU OPERATE THE MONITOR
<Back>
DisplayPort Cable (Not Included)
Mouse
USB Cable (Accessory)
HDMI Cable (Accessory)
Keyboard
Computer
AV Equipment