HP ProLiant C-GbE Reference Manual page 34

Configuring the Switch Modules using the Menu-driven Interface
Adding Unicast Filter Actions
To configure the Static Unicast Table:
1. Highlight Configure Static Unicast Table on the Configure Static (Destination-
Address Filtering) Table menu.
2. Press the Enter key. The following screen is displayed.
3. Toggle the Action field to Add/Modify.
NOTE: To delete the unicast filter action for a VLAN, toggle the Action field to Delete.
4. Type the VID in the VLAN ID field.
5. Type the MAC address to be statically entered in the forwarding table in the MAC
Address field.
6. Toggle the Type field to Permanent or DeleteOnReset, to set the unicast filter type.
Permanent maintains the filter permanently, until reconfigured. DeleteOnReset deletes
the filter when the port is reset.
7. Type the port number in the Allow to Go Port field.
8. Highlight APPLY.
9. Press the Enter key.
IMPORTANT: To save the configuration settings permanently, you must enter them into NVRAM
using the Save Changes option on the main menu. Refer to the "Saving Changes" section earlier
in this chapter.
2-24
HP CONFIDENTIAL Codename: DeLorean Part Number: 322858-001 Last Saved On: 2/4/03 11:56 AM
HP ProLiant BL e-Class C-GbE Interconnect Switch Menu-driven Interface Reference Guide