HP ProLiant C-GbE Reference Manual page 35

Interconnect switch menu-driven interface
Table of Contents

Advertisement

Adding Multicast Filter Actio
To edit the multicast filtering settings:
1. Highlight Configure Static Multicast Filtering Table on the Configure Static
(Destination-Address Filtering) Table.
2. Press the Enter key. The following screen is displayed.
3. Toggle the Action field to Add/Modify.
4. Type the VID number of the VLAN that will be receiving the multicast packets in the
VLAN ID field.
5. Type the MAC address of the multicast source in the Multicast MAC Address field.
6. Set the multicast group membership of each port by highlighting (E/-) field using the
arrow keys, and then toggling between E, F, or — using the space bar.
a. E (Egress Member)—Specifies the port as being a static member of the multicast
b. F (Forbidden Nonmember)—Specifies the port as not being a member of the
c. — (Nonmember)—Specifies the port as not being a member of the multicast group,
7. Toggle the Type field to the static multicast filter type Permanent or DeleteOnReset.
8. Highlight APPLY.
9. Press the Enter key.
IMPORTANT: To save the configuration settings permanently, you must enter them into NVRAM
using the Save Changes option on the main menu. Refer to the "Saving Changes" section earlier
in this chapter.
HP ProLiant BL e-Class C-GbE Interconnect Switch Menu-driven Interface Reference Guide
HP CONFIDENTIAL Codename: DeLorean Part Number: 322858-001 Last Saved On: 2/4/03 11:56 AM
ns
group. Egress Member Ports are ports that transmit traffic for the multicast group.
multicast group and that the port is forbidden from becoming a member of the
multicast group dynamically.
but the port can become a member of the multicast group dynamically.
Configuring the Switch Modules using the Menu-driven Interface
2-25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Proliant bl e-class c-cbe

Table of Contents