Section 2: Pc5102-433 Set Up & Wiring - DSC PC5102-433 Installation Manual

1.4 Batteries
The PWLS909-433/WLS909-433 use three A-76 batteries and the PWLS919-433/WLS919-
433 use two CR2032 lithium batteries.
Section 2: PC5102-433 Set Up & Wiring Section 2: PC5102-433 Set Up & Wiring Section 2: PC5102-433 Set Up & Wiring
Section 2: PC5102-433 Set Up & Wiring Section 2: PC5102-433 Set Up & Wiring
This section describes how to set up and wire the PC5102-433 module.
2.1 Choose a Mounting Location for the PC5102-433
NOTE NOTE: Mount the PC5102-433 receiver and wireless keys after you have done place- NOTE
NOTE NOTE
ment tests with the wireless keys (see sections 5.1 and 5.2).
Find a place that is (1) dry (2) close to the point of entry (3) high as possible and (4) far
from sources of interference, including: electrical noise (computers, televisions and
electric motors in appliances and heating and air conditioning units); large metal objects
like heating ducts and plumbing which may shield the antenna.
NOTE: Make sure that electrical wires will not run over the antenna of the module when it
is mounted.
When mounting the PC5102-433 in a basement, place the module as high and as close
to the underside of the first floor as possible. The range of the module will be reduced if
the unit is mounted below ground level.
2.2 Terminal Descriptions
The PC5102-433 has 2 on-board relay outputs which can be used in many different
applications. They can be used to activate LEDs, open garage doors, trigger X-10 devices etc.
NO1 NC1 COM1 NO2 NC2 COM2 RED
NO1- PGM1 Normally Open Relay Contact
NC1- PGM1 Normally Closed Relay Contact
COM1- PGM1 Relay Common Contact
NO2- PGM2 Normally Open Relay Contact
NC2- PGM2 Normally Closed Relay Contact
COM2- PGM2 Relay Common Contact
2.3 Connecting the PC5102-433 Receiver
CAUTION: Remove all power from the system while connecting modules to the Keybus .
Control Panel
RED BLK YEL GRN
NOTE: Each control panel may either have a PC5102 or a PC5132 enrolled but not both.
2.4 Connecting the LED to the PC5102-433
The LED can be used to indicate whether the
system is armed or disarmed. If the output is
programmed as an armed status output, the red
LED will turn on when the system is armed and
will turn off when the system is disarmed.
BLK YEL GRN
Connect the PC5102-433 to the four-wire Keybus of
the control panel according to the following dia-
gram.
After you have completed the wiring, reconnect the
power to the security system. Now that you have
wired the PC5102-433, you should enroll and pro-
KEYBUS TO
gram the wireless keys. See Section 3 for instruc-
PC5102
tions.
firealarmresources.com
RED- Keybus Power +12V
BLK- Keybus Ground
YEL- Keybus Clock
GRN- Keybus Data
ANT1 COM1 NO2
NO1 NC1
RED
BLACK
2
NC2 COM2 RED BLK YEL GRN